Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
clone item , change item category causes page reset
07-30-2015, 03:48 AM, (This post was last modified: 07-30-2015, 03:49 AM by archer62.)
#1
clone item , change item category causes page reset
not sure if this is a problem with the system or caused by my browser. When cloning an item, I setup the unique part number and description. Then move down to set the category. When I make the category change, the page tends to reset and the previous info entered reverts to the old data. I currently just set up and insert the item, then return back to the new part number to change the category. More of an annoyance than a problem, Others working that are new to the system have tried to insert and the system returns an error because the info is reset to a stock number that already exists. tks
Reply
07-30-2015, 07:45 PM,
#2
RE: clone item , change item category causes page reset
This is caused by the javascript used to update the item properties (if there are any item properties setup for either of the stock categories). This has never been correct and perhaps is best removed.

Thanks
Tim
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)