Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
4.07.6 WO does not do costing properly
04-18-2012, 08:14 PM
Post: #1
4.07.6 WO does not do costing properly
Used to work a few versions ago.

Product A Product B Ttl
unit cost before 2.05 1.48 606.04
Units before 196 138
unit cost after 2.05 1.507517241 606.04
Units After 189 145
Wrong cost after 2.05 2.05

The above summarize what I tried to do.
Product B is manufactured
1 product A makes 1 product B.
I manufacture 7 units of A to B. After manufacture, 7 units of A should move over with unit cost 2.05 thus bring up the average cost of B from 1.48 to 1.507 so that total A and B total cost remains at 606.04.
But it took over the Product A cost of 2.05.

Did I do something wrong?
set product B as manufactured.
set up BOM.
Open WO, receive items, update costing, close WO.
Find all posts by this user
Quote this message in a reply
04-19-2012, 03:48 PM
Post: #2
RE: 4.07.6 WO does not do costing properly
Hi, Rong:

What do you mean update costing? How do you do that and why?

Best regards!

Exson
Find all posts by this user
Quote this message in a reply
04-21-2012, 12:40 AM (This post was last modified: 04-21-2012 12:43 AM by ronwong.)
Post: #3
RE: 4.07.6 WO does not do costing properly
if i understand correctly, say 1 nut and 1 bolt makes a product, so if nut cost $1 and bolt cost $2, assume no labour cost etc, the end product will come out with a standard cost of $3.

In a closed system, if the erp system only have 1 nut and 1 bolt before the wo, the whole erp is worth $3, after the wo, there is zero nut and zero bolt and 1 end product, whole erp is still $3.

Now the before and after does not tie up. simple as that.

i manufacture 1 item to 1 item, you can assume that i have a blue nut, and i paint it red to make it a red one, assume not cost of labour or paint, i am really using it to "convert stocks" to move items between colours or attribute.
i think i phrase it wrong when i say update costing, we just click on the costing to receive the raw material or sometimg, just the standard WO process, we dont do any manual adjustment anywhere.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)