Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bug in mrp due date for top wo
04-17-2012, 04:30 PM, (This post was last modified: 04-17-2012, 04:53 PM by opto.)
#4
RE: bug in mrp due date for top wo
So that means if I have a 'make to stock' (no requirement due to a purchase order), the MRP planning will ask me to cancel that work order after running the MRP calculation.

I would call that a bug ...

Knowing that one has to be careful about the 'cancel' may be sufficient at the moment.

This took me half a day of debugging and looking at source code, and I came to the same conclusion (there is no requirement entered into the table).

I will add a remark to the wiki under MRP, so that others will not stumble at the same point as long as this is not updated.

thanks for your explanations,

Klaus




Proposal to correct this:

in levelnetting, where the date is changed: or when the rescheduling pdf is created, there we know the id of the wo that is proposed to be canceled.
If it is a make to stock, that wo has no reference to a po.
Can't we look that up and in this case print MTS instead of cancel?

Klaus
see note on http://www.weberp.org/MRP
Reply


Messages In This Thread
bug in mrp due date for top wo - by opto - 04-17-2012, 02:52 AM
RE: bug in mrp due date for top wo - by opto - 04-17-2012, 05:31 AM
RE: bug in mrp due date for top wo - by opto - 04-17-2012, 04:30 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)